Vader 5 Pro
Record trigger mode, PC connection and software profile. Browser timing cannot verify a polling-rate claim.
CONNECTION & TESTING GUIDE
Flydigi controller tester
Check Flydigi Vader, APEX and Direwolf inputs, with attention to PC modes, trigger settings and configuration profiles.
Connect with USB or Bluetooth, focus this page and press a controller button.
Choose a model reference (optional)
Your selection is recorded separately from the browser’s device identity.
Choose a model for setup notes. This does not change your inputs or identify hardware automatically.
Press any controller button to begin
Layout illustration only. The button grid shows the actual inputs received.
L2 / LT
R2 / RT
Resting-stick measurement
This describes the input exposed by your browser. Firmware and remapping software can already apply deadzones. These readings do not certify hardware condition.
Raw readings & input history
Indices are shown as reported by the browser. Unknown layouts are not assigned stick or trigger names.
Waiting for controller input.
GUIDED CHECKUP
Check every control.
- Buttons
- Triggers
- Stick drift
- Stick range
- Results
Connect a controller to begin.
Saved snapshots & comparison 0
Saved only when you choose, in this browser. Compare readings taken under the same conditions.
Connect your Flydigi controller
Choose the connection and PC input mode documented for the exact Vader, APEX or Direwolf model. A USB receiver and Bluetooth pairing can expose different capabilities.
These PC-oriented references are not a promise of Xbox or PlayStation console compatibility. Verify the intended platform separately before purchasing or using an adapter.
- Confirm the controller’s platform mode and supported connection. Use a USB data cable or the receiver specified for that exact model.
- Focus this page, press a face button and choose the responding device from the connected-controller menu.
- Press and release each control. Check raw indices if the device has no standard mapping.
- Record your connection, software profile and trigger-stop setting before saving a snapshot.
MODEL NOTES
Choose your Flydigi
Vader 4 Pro
Follow the exact model’s PC-mode instructions and keep trigger/response settings consistent.
APEX 5
Check its supported computer connection and profile; do not infer Xbox/PlayStation support from a browser reading.
Direwolf 3
Record the input mode and connection, then check direct button and rear assignments separately.
Compare the same trigger and stick configuration
Vader-family trigger modes and software settings can change travel and reported response. Note the mode before expecting a gradual trigger sweep.
Extra controls can be assigned to an existing gamepad action or another input type. Check what the assignment is meant to send before interpreting a missing independent gamepad button.
Record firmware, configuration software profile, connection and any stick-response settings in your setup note. A different response curve can change the trace without identifying a damaged component.
Turn a reading into a useful comparison
Check one variable at a time. For unwanted stick movement, release the sticks onto a stable surface and run the ten-second resting test. For a missing action, compare a direct button press with its rear-button assignment. Save a note identifying the active profile so a later result can be reproduced.
The browser-reported device name can describe a virtual gamepad. The optional model reference is your selection, not automatic hardware identification. Brand listing does not guarantee vibration, independent paddles or vendor-specific controls in your browser.
Manufacturer references
Documentation reviewed 29 October 2026. Setup guidance, not a hands-on product review or a certification of browser support.