Skip to content
ControllerTesterControllerTesterTest controller

CONNECTION & TESTING GUIDE

Logitech controller tester

Check Logitech F310 and F710 inputs and understand how their XInput/DirectInput switch changes gamepad mapping.

Live controller test

Waiting for a controller

Connect with USB or Bluetooth, focus this page and press a controller button.

Choose a model reference (optional)
Your selection is recorded separately from the browser’s device identity.

Choose a model for setup notes. This does not change your inputs or identify hardware automatically.

Controller layout reference
Press any controller button to begin

Layout illustration only. The button grid shows the actual inputs received.

L2 / LT—
R2 / RT—
Buttons detectedWaiting for input

Raw readings & input history

Indices are shown as reported by the browser. Unknown layouts are not assigned stick or trigger names.

Waiting for controller input.
    Saved snapshots & comparison 0

    Saved only when you choose, in this browser. Compare readings taken under the same conditions.

    Connect your Logitech controller

    F310 uses a wired USB connection. F710 uses its wireless USB receiver; it is not a Bluetooth gamepad. Check the receiver when troubleshooting a missing F710.

    Both families provide XInput and DirectInput modes. Use the mode appropriate for your application, and note the switch position before comparing results.

    1. Confirm the controller’s platform mode and supported connection. Use a USB data cable or the receiver specified for that exact model.
    2. Focus this page, press a face button and choose the responding device from the connected-controller menu.
    3. Press and release each control. Check raw indices if the device has no standard mapping.
    4. Record your connection, software profile and trigger-stop setting before saving a snapshot.

    MODEL NOTES

    Choose your Logitech

    Detection and a standard mapping are different

    A controller can be detected while exposing non-standard button or axis indices. In that case, open raw readings and check which values change. The tester deliberately avoids inventing a stick layout.

    Changing X/D mode can change the mapping or device identity. Start a new session after switching modes and compare only recordings with the intended configuration.

    For a wireless F710, confirm receiver connection and controller power before investigating browser settings. For either model, test a face button first, then check the direction controls and triggers separately.

    Turn a reading into a useful comparison

    Check one variable at a time. For unwanted stick movement, release the sticks onto a stable surface and run the ten-second resting test. For a missing action, compare a direct button press with its rear-button assignment. Save a note identifying the active profile so a later result can be reproduced.

    The browser-reported device name can describe a virtual gamepad. The optional model reference is your selection, not automatic hardware identification. Brand listing does not guarantee vibration, independent paddles or vendor-specific controls in your browser.

    Buttons & triggers → Resting stick test → Connection help →

    Manufacturer references

    Documentation reviewed 29 October 2026. Setup guidance, not a hands-on product review or a certification of browser support.