Use the same connection, firmware and profile when repeating a check. These measurements describe browser input and do not assign a hardware health score.
Choose a guided measurement.
Trigger Travel · Last 6 Seconds
Slowly squeeze and release each trigger. A digital or instant-trigger mode can jump directly between endpoints.
— Left trigger– – Right trigger
Observed Press / Release Counts
↓ Presses · ↑ Releases. Counts start at observed state transitions; a control already held when sampling begins has no recorded press. Brief events between browser samples can be missed.
How to read these measurements
The guided sweep records the greatest radius in each of 32 direction sectors. A direction counts as covered at radius 0.75. Outline deviation is the mean absolute difference from radius 1, shown only after all directions are covered. An intended square response can have higher deviation.
Centring records four releases per stick: left, right, up and down. After input returns below radius 0.5, it settles for 0.4 seconds and averages the following 0.4 seconds, with at least five samples. Position spread is the greatest distance from the average of those four positions. Filtering can affect all results. This is not a latency or hardware polling-rate test.
Connect a controller to check browser rumble support.
Did you feel the vibration?
Resting-Stick Measurement
This describes the input exposed by your browser. Firmware and remapping software can already apply deadzones. These readings do not certify hardware condition.
Raw readings & input history
Indices are shown as reported by the browser. Unknown layouts are not assigned stick or trigger names.
Waiting for controller input.
GUIDED CHECKUP
Check Every Control.
Step 1 of 5
Buttons
Triggers
Stick drift
Stick range
Results
Connect a controller to begin.
Save, export or compare this session
KEEP YOUR BASELINE
Save Or Export This Session
Stored on this device
Snapshots stay in this browser. Export a report before clearing site data or moving to another device.
Saved snapshots & comparison 0
Choose two records to compare. Imported files are checked locally and never uploaded.
By EmuCores · Setup guide · Updated 30 October 2026
Connect Your HORI Controller
Wireless HORIPAD for Steam supports XInput over USB, not Bluetooth, according to its support guidance. A Bluetooth connection therefore should not be assumed to produce the same standard gamepad layout.
Fighting Commander OCTA for Windows is a fightpad, not a conventional two-stick controller. Match the exact platform edition and switch settings before interpreting its button and axis counts.
Confirm the controller’s platform mode and supported connection. Use a USB data cable or the receiver specified for that exact model.
Focus this page, press a face button and choose the responding device from the connected-controller menu.
Press and release each control. Check raw indices if the device has no standard mapping.
Record your connection, software profile and trigger-stop setting before saving a snapshot.
Model setup at a glance — PC connection guidance
Model
Connection to check
Setup / interpretation
Wireless HORIPAD for Steam
USB / Bluetooth
XInput is documented over USB only. Bluetooth can expose a different input path. Manufacturer guidance
Fighting Commander OCTA — Windows
USB
Fightpad layout: inspect actual button/axis responses rather than expecting two physical sticks. Manufacturer guidance
Connections vary by edition and operating system. This table records setup guidance, not a physically verified browser result.
MODEL NOTES
Choose Your HORI
ControllerTester illustration
HORI
Wireless HORIPAD For Steam
USB · Bluetooth
A Steam-focused controller with touch-sensitive sticks, motion sensing and extra buttons. XInput works through its wired connection.
Specifications & testing tips
Platforms
PC
PC connections
USB / Bluetooth
Configuration
HORI model-specific support / Steam Input
Extra controls
Two rear buttons; two function buttons
Triggers
Analog / digital modes
Sensors
Gyro and capacitive-touch sticks
Feedback
No vibration
PC mode
XInput is wired only
Before You Test
XInput is documented over USB only. Bluetooth can expose a different input path.
Start with the normal manufacturer-supported PC connection. Record firmware, connection and profile before saving a snapshot.
What To Check Here
Press each face button and direction once. Use the raw input list if the browser has no standard mapping.
Move the sticks around their range, release them and run the resting-stick test. Save the active profile alongside the results.
Squeeze and release both triggers. A short-travel or digital mode can change the values you observe.
Rear buttons can repeat existing inputs. Browser rumble does not test motion sensors, audio or adaptive-trigger resistance.
Illustration reference: Model appearance reference. AI-generated illustration based on the model reference; small details and colour may vary. Colour and included accessories may vary.
Illustration reference: Model appearance reference. AI-generated illustration based on the model reference; small details and colour may vary. Colour and included accessories may vary.
For a fightpad, concentrate on the D-pad, face buttons, shoulders and any fitted stick. A standard-looking browser mapping is not proof that the device physically has two analog sticks or analog triggers.
Check directional inputs one at a time and then diagonally. If a mode switch changes whether a direction appears as buttons or axes, save a note and start a fresh comparison.
Steam Input can add a virtual mapping to HORIPAD for Steam. Record whether that software is active and select the responding device instead of assuming the first gamepad entry is the physical controller.
Turn A Reading Into A Useful Comparison
Check one variable at a time. For unwanted stick movement, release the sticks onto a stable surface and run the ten-second resting test. For a missing action, compare a direct button press with its rear-button assignment. Save a note identifying the active profile so a later result can be reproduced.
The browser-reported device name can describe a virtual gamepad. The optional model reference is your selection, not automatic hardware identification. Brand listing does not guarantee vibration, independent paddles or vendor-specific controls in your browser.
No. Fightpads can have different physical controls. Skip inapplicable guided steps and inspect actual D-pad/button readings. A reported standard mapping can include virtual controls.
Why is HORIPAD for Steam different over USB?
HORI documents XInput over USB for that model. Bluetooth and Steam Input may expose another input path. Keep the connection and active layout in your setup note.
Documentation reviewed 29 October 2026. Setup guidance, not a hands-on product review or a certification of browser support.
ControllerTester illustration